6 # The "linelog" module will log one line of text to a file.
7 # Both the filename and the line of text are dynamically expanded.
9 # We STRONGLY suggest that you do not use data from the
10 # packet as part of the filename.
14 # The file where the logs will go.
16 # If the filename is "syslog", then the log messages will
18 filename = ${logdir}/linelog
21 # The default format string.
22 format = "This is a log message for %{User-Name}"
25 # This next line can be omitted. If it is omitted, then
26 # the log message is static, and is always given by "format",
29 # If it is defined, then the string is dynamically expanded,
30 # and the result is used to find another configuration entry
31 # here, with the given name. That name is then used as the
34 # If the configuration entry cannot be found, then no log
37 # i.e. You can have many log messages in one "linelog" module.
38 # If this two-step expansion did not exist, you would have
39 # needed to configure one "linelog" module for each log message.
42 # Reference the Packet-Type (Access-Request, etc.) If it doesn't
43 # exist, reference the "format" entry, above.
44 reference = "%{%{Packet-Type}:-format}"
47 # Followed by a series of log messages.
48 Access-Request = "Requested access: %{User-Name}"
49 Access-Reject = "Rejected access: %{User-Name}"
50 Access-Challenge = "Sent challenge: %{User-Name}"
53 # The log messages can be grouped into sections and
54 # sub-sections, too. The "reference" item needs to have a "."
55 # for every section. e.g. reference = foo.bar will reference
56 # the "foo" section, "bar" configuration item.
60 # Used if: reference = "foo.bar".
62 bar = "Example log. Please ignore"
67 # reference = "Accounting-Request.%{%{Acct-Status-Type}:-unknown}"
70 Start = "Connect: [%{User-Name}] (did %{Called-Station-Id} cli %{Calling-Station-Id} port %{NAS-Port} ip %{Framed-IP-Address})"
71 Stop = "Disconnect: [%{User-Name}] (did %{Called-Station-Id} cli %{Calling-Station-Id} port %{NAS-Port} ip %{Framed-IP-Address}) %{Acct-Session-Time} seconds"
73 # Don't log anything for these packets.
76 Accounting-On = "NAS %C (%{NAS-IP-Address}) just came online"
77 Accounting-Off = "NAS %C (%{NAS-IP-Address}) just went offline"
79 # don't log anything for other Acct-Status-Types.