# Driver interface for wired authenticator
#CONFIG_DRIVER_WIRED=y
-# Driver interface for madwifi driver
-#CONFIG_DRIVER_MADWIFI=y
-#CFLAGS += -I../../madwifi # change to the madwifi source directory
-
# Driver interface for drivers using the nl80211 kernel interface
#CONFIG_DRIVER_NL80211=y
# driver_nl80211.c requires a rather new libnl (version 1.1) which may not be
#LIBS += -L$(LIBNL)/lib
CONFIG_LIBNL20=y
+# QCA vendor extensions to nl80211
+CONFIG_DRIVER_NL80211_QCA=y
+
# Driver interface for FreeBSD net80211 layer (e.g., Atheros driver)
#CONFIG_DRIVER_BSD=y
#CFLAGS += -I/usr/local/include
# This version is an experimental implementation based on IEEE 802.11w/D1.0
# draft and is subject to change since the standard has not yet been finalized.
# Driver support is also needed for IEEE 802.11w.
-#CONFIG_IEEE80211W=y
+CONFIG_IEEE80211W=y
# Integrated EAP server
#CONFIG_EAP=y
# Wi-Fi Protected Setup (WPS)
CONFIG_WPS=y
-# Enable WSC 2.0 support
-CONFIG_WPS2=y
# Enable UPnP support for external WPS Registrars
#CONFIG_WPS_UPNP=y
#CONFIG_IEEE80211R=y
# Use the hostapd's IEEE 802.11 authentication (ACL), but without
-# the IEEE 802.11 Management capability (e.g., madwifi or FreeBSD/net80211)
+# the IEEE 802.11 Management capability (e.g., FreeBSD/net80211)
#CONFIG_DRIVER_RADIUS_ACL=y
# IEEE 802.11n (High Throughput) support
# Remove support for VLANs
#CONFIG_NO_VLAN=y
-# Remove support for dumping state into a file on SIGUSR1 signal
+# Remove support for dumping internal state through control interface commands
# This can be used to reduce binary size at the cost of disabling a debugging
# option.
#CONFIG_NO_DUMP_STATE=y
#LIBS_p += -lbfd -liberty -lz
#LIBS_c += -lbfd -liberty -lz
+# Should we use poll instead of select? Select is used by default.
+#CONFIG_ELOOP_POLL=y
+
+# Should we use epoll instead of select? Select is used by default.
+#CONFIG_ELOOP_EPOLL=y
+
# Enable AP
CONFIG_AP=y
+
+# Enable Fast Session Transfer (FST)
+#CONFIG_FST=y
+
+# Multiband Operation support
+# These extentions facilitate efficient use of multiple frequency bands
+# available to the AP and the devices that may associate with it.
+#CONFIG_MBO=y