# Driver interface for drivers using the nl80211 kernel interface
CONFIG_DRIVER_NL80211=y
+# driver_nl80211.c requires libnl. If you are compiling it yourself
+# you may need to point hostapd to your version of libnl.
+#
+#CFLAGS += -I$<path to libnl include files>
+#LIBS += -L$<path to libnl library files>
+
+# Use libnl v2.0 (or 3.0) libraries.
+#CONFIG_LIBNL20=y
+
+# Use libnl 3.2 libraries (if this is selected, CONFIG_LIBNL20 is ignored)
+#CONFIG_LIBNL32=y
+
+
# Driver interface for FreeBSD net80211 layer (e.g., Atheros driver)
#CONFIG_DRIVER_BSD=y
#CFLAGS += -I/usr/local/include
CONFIG_PEERKEY=y
# IEEE 802.11w (management frame protection)
-# This version is an experimental implementation based on IEEE 802.11w/D1.0
-# draft and is subject to change since the standard has not yet been finalized.
-# Driver support is also needed for IEEE 802.11w.
-#CONFIG_IEEE80211W=y
+CONFIG_IEEE80211W=y
# Integrated EAP server
CONFIG_EAP=y
#CONFIG_EAP_GPSK_SHA256=y
# EAP-FAST for the integrated EAP server
-# Note: Default OpenSSL package does not include support for all the
-# functionality needed for EAP-FAST. If EAP-FAST is enabled with OpenSSL,
-# the OpenSSL library must be patched (openssl-0.9.9-session-ticket.patch)
-# to add the needed functions.
+# Note: If OpenSSL is used as the TLS library, OpenSSL 1.0 or newer is needed
+# for EAP-FAST support. Older OpenSSL releases would need to be patched, e.g.,
+# with openssl-0.9.8x-tls-extensions.patch, to add the needed functions.
#CONFIG_EAP_FAST=y
# Wi-Fi Protected Setup (WPS)
#CONFIG_WPS=y
-# Enable WSC 2.0 support
-#CONFIG_WPS2=y
# Enable UPnP support for external WPS Registrars
#CONFIG_WPS_UPNP=y
# Enable WPS support with NFC config method
# Disabled by default.
#CONFIG_DEBUG_FILE=y
+# Add support for sending all debug messages (regardless of debug verbosity)
+# to the Linux kernel tracing facility. This helps debug the entire stack by
+# making it easy to record everything happening from the driver up into the
+# same file, e.g., using trace-cmd.
+#CONFIG_DEBUG_LINUX_TRACING=y
+
# Remove support for RADIUS accounting
#CONFIG_NO_ACCOUNTING=y
# Note: This requires libnl 3.1 or newer.
#CONFIG_VLAN_NETLINK=y
-# Remove support for dumping state into a file on SIGUSR1 signal
+# Remove support for dumping internal state through control interface commands
# This can be used to reduce binary size at the cost of disabling a debugging
# option.
#CONFIG_NO_DUMP_STATE=y