Support for Solaris default shell restriction

[libeap.git] / hostapd / hostapd.conf

diff --git a/hostapd/hostapd.conf b/hostapd/hostapd.conf
index 6254496..041b947 100644 (file)
--- a/hostapd/hostapd.conf
+++ b/hostapd/hostapd.conf
@@ -5,9 +5,17 @@
 # management frames); ath0 for madwifi
 interface=wlan0
 
-# In case of madwifi and nl80211 driver interfaces, an additional configuration
-# parameter, bridge, must be used to notify hostapd if the interface is
-# included in a bridge. This parameter is not used with Host AP driver.
+# In case of madwifi, atheros, and nl80211 driver interfaces, an additional
+# configuration parameter, bridge, may be used to notify hostapd if the
+# interface is included in a bridge. This parameter is not used with Host AP
+# driver. If the bridge parameter is not set, the drivers will automatically
+# figure out the bridge interface (assuming sysfs is enabled and mounted to
+# /sys) and this parameter may not be needed.
+#
+# For nl80211, this parameter can be used to request the AP interface to be
+# added to the bridge automatically (brctl may refuse to do this before hostapd
+# has been started to change the interface mode). If needed, the bridge
+# interface is also created.
 #bridge=br0
 
 # Driver interface type (hostap/wired/madwifi/test/none/nl80211/bsd);
@@ -275,6 +283,10 @@ ignore_broadcast_ssid=0
 #
 wmm_enabled=1
 #
+# WMM-PS Unscheduled Automatic Power Save Delivery [U-APSD]
+# Enable this flag if U-APSD supported outside hostapd (eg., Firmware/driver)
+#uapsd_advertisement_enabled=1
+#
 # Low priority / AC_BK = background
 wmm_ac_bk_cwmin=4
 wmm_ac_bk_cwmax=10
@@ -346,6 +358,12 @@ wmm_ac_vo_acm=0
 # remain asleep). Default: 65535 (no limit apart from field size)
 #max_listen_interval=100
 
+# WDS (4-address frame) mode with per-station virtual interfaces
+# (only supported with driver=nl80211)
+# This mode allows associated stations to use 4-address frames to allow layer 2
+# bridging to be used.
+#wds_sta=1
+
 ##### IEEE 802.11n related configuration ######################################
 
 # ieee80211n: Whether IEEE 802.11n (HT) is enabled
@@ -788,7 +806,7 @@ own_ip_addr=127.0.0.1
 # And so on.. One line per R0KH.
 
 # List of R1KHs in the same Mobility Domain
-# format: <MAC address> <R0KH-ID> <128-bit key as hex string>
+# format: <MAC address> <R1KH-ID> <128-bit key as hex string>
 # This list is used to map R1KH-ID to a destination MAC address when sending
 # PMK-R1 key from the R0KH. This is also the list of authorized R1KHs in the MD
 # that can request PMK-R1 keys.