# Test connectivity 0->1 and 1->0
hwsim_utils.test_connectivity(dev[0], dev[1])
+ state = dev[0].get_status_field("wpa_state")
+ if state != "COMPLETED":
+ raise Exception("Unexpected wpa_state on dev0: " + state)
+ state = dev[1].get_status_field("wpa_state")
+ if state != "COMPLETED":
+ raise Exception("Unexpected wpa_state on dev1: " + state)
+
def test_wpas_mesh_open_no_auto(dev, apdev):
"""wpa_supplicant open MESH network connectivity"""
check_mesh_support(dev[0])
# Test connectivity 0->1 and 1->0
hwsim_utils.test_connectivity(dev[0], dev[1])
+def test_mesh_open_no_auto2(dev, apdev):
+ """Open mesh network connectivity, no_auto on both peers"""
+ check_mesh_support(dev[0])
+ id = add_open_mesh_network(dev[0], start=False)
+ dev[0].set_network(id, "no_auto_peer", "1")
+ dev[0].mesh_group_add(id)
+
+ id = add_open_mesh_network(dev[1], start=False)
+ dev[1].set_network(id, "no_auto_peer", "1")
+ dev[1].mesh_group_add(id)
+
+ check_mesh_group_added(dev[0])
+ check_mesh_group_added(dev[1])
+
+ ev = dev[0].wait_event(["will not initiate new peer link"], timeout=10)
+ if ev is None:
+ raise Exception("Missing no-initiate message")
+ addr1 = dev[1].own_addr()
+ if "OK" not in dev[0].request("MESH_PEER_ADD " + addr1):
+ raise Exception("MESH_PEER_ADD failed")
+ if "FAIL" not in dev[0].request("MESH_PEER_ADD ff:ff:ff:ff:ff:ff"):
+ raise Exception("MESH_PEER_ADD with unknown STA succeeded")
+ check_mesh_peer_connected(dev[0], timeout=30)
+ check_mesh_peer_connected(dev[1])
+ if "FAIL" not in dev[0].request("MESH_PEER_ADD " + addr1):
+ raise Exception("MESH_PEER_ADD succeeded for connected STA")
+ hwsim_utils.test_connectivity(dev[0], dev[1])
+
def add_mesh_secure_net(dev, psk=True, pmf=False, pairwise=None, group=None):
id = dev.add_network()
dev.set_network(id, "mode", "5")
# Test connectivity 0->1 and 1->0
hwsim_utils.test_connectivity(dev[0], dev[1])
+ state = dev[0].get_status_field("wpa_state")
+ if state != "COMPLETED":
+ raise Exception("Unexpected wpa_state on dev0: " + state)
+ state = dev[1].get_status_field("wpa_state")
+ if state != "COMPLETED":
+ raise Exception("Unexpected wpa_state on dev1: " + state)
+
def test_mesh_secure_pmf(dev, apdev):
"""Secure mesh network connectivity with PMF enabled"""
check_mesh_support(dev[0], secure=True)
# Test connectivity 0->1 and 1->0
hwsim_utils.test_connectivity(dev[0], dev[1])
+def test_mesh_secure_fail(dev, apdev):
+ """Secure mesh network connectivity failure"""
+ check_mesh_support(dev[0], secure=True)
+ dev[0].request("SET sae_groups ")
+ id = add_mesh_secure_net(dev[0], pmf=True)
+ dev[0].mesh_group_add(id)
+
+ dev[1].request("SET sae_groups ")
+ id = add_mesh_secure_net(dev[1], pmf=True)
+
+ with fail_test(dev[0], 1, "wpa_driver_nl80211_sta_add;mesh_mpm_auth_peer"):
+ dev[1].mesh_group_add(id)
+
+ check_mesh_group_added(dev[0])
+ check_mesh_group_added(dev[1])
+
+ check_mesh_peer_connected(dev[0])
+ check_mesh_peer_connected(dev[1])
+
def test_wpas_mesh_ctrl(dev):
"""wpa_supplicant ctrl_iface mesh command error cases"""
check_mesh_support(dev[0])
if test != 7:
raise Exception("Not all test frames completed")
+
+def test_mesh_mpm_init_proto(dev, apdev):
+ """Mesh peering management protocol testing for peer addition"""
+ check_mesh_support(dev[0])
+ add_open_mesh_network(dev[0])
+ check_mesh_group_added(dev[0])
+ dev[0].dump_monitor()
+
+ dev[0].request("SET ext_mgmt_frame_handling 1")
+
+ addr = "020000000100"
+ hdr = "d000ac00020000000000" + addr + addr + "1000"
+ fixed = "0f010000"
+ supp_rates = "010802040b168c129824"
+ ext_supp_rates = "3204b048606c"
+ mesh_id = "720e777061732d6d6573682d6f70656e"
+ mesh_conf = "710701010001000009"
+ mpm = "75040000079d"
+ ht_capab = "2d1a7c001bffff000000000000000000000100000000000000000000"
+ ht_oper = "3d160b000000000000000000000000000000000000000000"
+
+ dev[0].request("NOTE no supported rates")
+ frame = hdr + fixed + ext_supp_rates + mesh_id + mesh_conf + mpm + ht_capab + ht_oper
+ if "OK" not in dev[0].request("MGMT_RX_PROCESS freq=2412 datarate=0 ssi_signal=-30 frame=%s" % frame):
+ raise Exception("MGMT_RX_PROCESS failed")
+
+ dev[0].request("NOTE Invalid supported rates element length 33+0")
+ long_supp_rates = "012100112233445566778899aabbccddeeff00112233445566778899aabbccddeeff00"
+ frame = hdr + fixed + long_supp_rates + mesh_id + mesh_conf + mpm + ht_capab + ht_oper
+ if "OK" not in dev[0].request("MGMT_RX_PROCESS freq=2412 datarate=0 ssi_signal=-30 frame=%s" % frame):
+ raise Exception("MGMT_RX_PROCESS failed")
+
+ dev[0].request("NOTE Too short mesh config")
+ short_mesh_conf = "710401010001"
+ frame = hdr + fixed + supp_rates + mesh_id + short_mesh_conf + mpm + ht_capab + ht_oper
+ if "OK" not in dev[0].request("MGMT_RX_PROCESS freq=2412 datarate=0 ssi_signal=-30 frame=%s" % frame):
+ raise Exception("MGMT_RX_PROCESS failed")
+
+ dev[0].request("NOTE Add STA failure")
+ frame = hdr + fixed + supp_rates + ext_supp_rates + mesh_id + mesh_conf + mpm + ht_capab + ht_oper
+ with fail_test(dev[0], 1, "wpa_driver_nl80211_sta_add"):
+ if "OK" not in dev[0].request("MGMT_RX_PROCESS freq=2412 datarate=0 ssi_signal=-30 frame=%s" % frame):
+ raise Exception("MGMT_RX_PROCESS failed")
+
+ dev[0].request("NOTE Send Action failure")
+ with fail_test(dev[0], 1, "driver_nl80211_send_action"):
+ if "OK" not in dev[0].request("MGMT_RX_PROCESS freq=2412 datarate=0 ssi_signal=-30 frame=%s" % frame):
+ raise Exception("MGMT_RX_PROCESS failed")
+
+ dev[0].request("NOTE Set STA failure")
+ addr = "020000000101"
+ hdr = "d000ac00020000000000" + addr + addr + "1000"
+ frame = hdr + fixed + supp_rates + ext_supp_rates + mesh_id + mesh_conf + mpm + ht_capab + ht_oper
+ with fail_test(dev[0], 2, "wpa_driver_nl80211_sta_add"):
+ if "OK" not in dev[0].request("MGMT_RX_PROCESS freq=2412 datarate=0 ssi_signal=-30 frame=%s" % frame):
+ raise Exception("MGMT_RX_PROCESS failed")
+
+ dev[0].request("NOTE ap_sta_add OOM")
+ addr = "020000000102"
+ hdr = "d000ac00020000000000" + addr + addr + "1000"
+ frame = hdr + fixed + supp_rates + ext_supp_rates + mesh_id + mesh_conf + mpm + ht_capab + ht_oper
+ with alloc_fail(dev[0], 1, "ap_sta_add"):
+ if "OK" not in dev[0].request("MGMT_RX_PROCESS freq=2412 datarate=0 ssi_signal=-30 frame=%s" % frame):
+ raise Exception("MGMT_RX_PROCESS failed")
+
+ dev[0].request("NOTE hostapd_get_aid() failure")
+ addr = "020000000103"
+ hdr = "d000ac00020000000000" + addr + addr + "1000"
+ frame = hdr + fixed + supp_rates + ext_supp_rates + mesh_id + mesh_conf + mpm + ht_capab + ht_oper
+ with fail_test(dev[0], 1, "hostapd_get_aid"):
+ if "OK" not in dev[0].request("MGMT_RX_PROCESS freq=2412 datarate=0 ssi_signal=-30 frame=%s" % frame):
+ raise Exception("MGMT_RX_PROCESS failed")
+
+ if "OK" not in dev[0].request("MESH_PEER_REMOVE 02:00:00:00:01:00"):
+ raise Exception("Failed to remove peer")
+ if "FAIL" not in dev[0].request("MESH_PEER_REMOVE 02:00:00:00:01:02"):
+ raise Exception("Unexpected MESH_PEER_REMOVE success")
+ if "FAIL" not in dev[1].request("MESH_PEER_REMOVE 02:00:00:00:01:02"):
+ raise Exception("Unexpected MESH_PEER_REMOVE success(2)")
+ if "FAIL" not in dev[1].request("MESH_PEER_ADD 02:00:00:00:01:02"):
+ raise Exception("Unexpected MESH_PEER_ADD success")
projects / mech_eap.git / blobdiff