Make it clearer that ap_scan=2 mode should not be used with nl80211

[mech_eap.git] / wpa_supplicant / wpa_supplicant.conf

diff --git a/wpa_supplicant/wpa_supplicant.conf b/wpa_supplicant/wpa_supplicant.conf
index d380965..6fe67e4 100644 (file)
--- a/wpa_supplicant/wpa_supplicant.conf
+++ b/wpa_supplicant/wpa_supplicant.conf
@@ -108,6 +108,10 @@ eapol_version=1
 #    the driver reports successful association; each network block should have
 #    explicit security policy (i.e., only one option in the lists) for
 #    key_mgmt, pairwise, group, proto variables
+# Note: ap_scan=2 should not be used with the nl80211 driver interface (the
+# current Linux interface). ap_scan=1 is optimized work working with nl80211.
+# For finding networks using hidden SSID, scan_ssid=1 in the network block can
+# be used with nl80211.
 # When using IBSS or AP mode, ap_scan=2 mode can force the new network to be
 # created immediately regardless of scan results. ap_scan=1 mode will first try
 # to scan for existing networks and only if no matches with the enabled
@@ -986,6 +990,7 @@ fast_reauth=1
 #      EAP workarounds are disabled with eap_workaround=0.
 #      For EAP-FAST, this must be set to 0 (or left unconfigured for the
 #      default value to be used automatically).
+# tls_disable_tlsv1_0=1 - disable use of TLSv1.0
 # tls_disable_tlsv1_1=1 - disable use of TLSv1.1 (a workaround for AAA servers
 #      that have issues interoperating with updated TLS version)
 # tls_disable_tlsv1_2=1 - disable use of TLSv1.2 (a workaround for AAA servers
@@ -1136,6 +1141,32 @@ fast_reauth=1
 #  2: MCS 0-9
 #  3: not supported
 
+##### Fast Session Transfer (FST) support #####################################
+#
+# The options in this section are only available when the build configuration
+# option CONFIG_FST is set while compiling hostapd. They allow this interface
+# to be a part of FST setup.
+#
+# FST is the transfer of a session from a channel to another channel, in the
+# same or different frequency bands.
+#
+# For detals, see IEEE Std 802.11ad-2012.
+
+# Identifier of an FST Group  the interface belongs to.
+#fst_group_id=bond0
+
+# Interface priority within the FST Group.
+# Announcing a higher priority for an interface means declaring it more
+# preferable for FST switch.
+# fst_priority is in 1..255 range with 1 being the lowest priority.
+#fst_priority=100
+
+# Default LLT value for this interface in milliseconds. The value used in case
+# no value provided during session setup. Default is 50 msec.
+# fst_llt is in 1..4294967 range (due to spec limitation, see 10.32.2.2
+# Transitioning between states).
+#fst_llt=100
+
 # Example blocks:
 
 # Simple case: WPA-PSK, PSK as an ASCII passphrase, allow all valid ciphers