-static const char *commands_help =
-"commands:\n"
-" status [verbose] = get current WPA/EAPOL/EAP status\n"
-" mib = get MIB variables (dot1x, dot11)\n"
-" help = show this usage help\n"
-" interface [ifname] = show interfaces/select interface\n"
-" level <debug level> = change debug level\n"
-" license = show full wpa_cli license\n"
-" logoff = IEEE 802.1X EAPOL state machine logoff\n"
-" logon = IEEE 802.1X EAPOL state machine logon\n"
-" set = set variables (shows list of variables when run without arguments)\n"
-" pmksa = show PMKSA cache\n"
-" reassociate = force reassociation\n"
-" reconfigure = force wpa_supplicant to re-read its configuration file\n"
-" preauthenticate <BSSID> = force preauthentication\n"
-" identity <network id> <identity> = configure identity for an SSID\n"
-" password <network id> <password> = configure password for an SSID\n"
-" new_password <network id> <password> = change password for an SSID\n"
-" pin <network id> <pin> = configure pin for an SSID\n"
-" otp <network id> <password> = configure one-time-password for an SSID\n"
-" passphrase <network id> <passphrase> = configure private key passphrase\n"
-" for an SSID\n"
-" bssid <network id> <BSSID> = set preferred BSSID for an SSID\n"
-" list_networks = list configured networks\n"
-" select_network <network id> = select a network (disable others)\n"
-" enable_network <network id> = enable a network\n"
-" disable_network <network id> = disable a network\n"
-" add_network = add a network\n"
-" remove_network <network id> = remove a network\n"
-" set_network <network id> <variable> <value> = set network variables "
-"(shows\n"
-" list of variables when run without arguments)\n"
-" get_network <network id> <variable> = get network variables\n"
-" save_config = save the current configuration\n"
-" disconnect = disconnect and wait for reassociate/reconnect command before\n "
-" connecting\n"
-" reconnect = like reassociate, but only takes effect if already "
-"disconnected\n"
-" scan = request new BSS scan\n"
-" scan_results = get latest scan results\n"
-" bss <<idx> | <bssid>> = get detailed scan result info\n"
-" get_capability <eap/pairwise/group/key_mgmt/proto/auth_alg> = "
-"get capabilies\n"
-" ap_scan <value> = set ap_scan parameter\n"
-" stkstart <addr> = request STK negotiation with <addr>\n"
-" ft_ds <addr> = request over-the-DS FT with <addr>\n"
-" wps_pbc [BSSID] = start Wi-Fi Protected Setup: Push Button Configuration\n"
-" wps_pin <BSSID> [PIN] = start WPS PIN method (returns PIN, if not "
-"hardcoded)\n"
-" wps_reg <BSSID> <AP PIN> = start WPS Registrar to configure an AP\n"
-" terminate = terminate wpa_supplicant\n"
-" quit = exit wpa_cli\n";
-