# AP netdevice name (without 'ap' postfix, i.e., wlan0 uses wlan0ap for
# management frames with the Host AP driver); wlan0 with many nl80211 drivers
+# Note: This attribute can be overridden by the values supplied with the '-i'
+# command line parameter.
interface=wlan0
# In case of atheros and nl80211 driver interfaces, an additional
#
#vht_oper_centr_freq_seg1_idx=159
+# Workaround to use station's nsts capability in (Re)Association Response frame
+# This may be needed with some deployed devices as an interoperability
+# workaround for beamforming if the AP's capability is greater than the
+# station's capability. This is disabled by default and can be enabled by
+# setting use_sta_nsts=1.
+#use_sta_nsts=0
+
##### IEEE 802.1X-2004 related configuration ##################################
# Require IEEE 802.1X authorization
#
# DAS require Event-Timestamp
#radius_das_require_event_timestamp=1
+#
+# DAS require Message-Authenticator
+#radius_das_require_message_authenticator=1
##### RADIUS authentication server configuration ##############################
# For example, AP Civic Location ANQP-element with unknown location:
#anqp_elem=266:000000
+# GAS Address 3 behavior
+# 0 = P2P specification (Address3 = AP BSSID) workaround enabled by default
+# based on GAS request Address3
+# 1 = IEEE 802.11 standard compliant regardless of GAS request Address3
+# 2 = Force non-compliant behavior (Address3 = AP BSSID for all cases)
+#gas_address3=0
+
# QoS Map Set configuration
#
# Comma delimited QoS Map Set in decimal values
# Enable neighbor report via radio measurements
#rrm_neighbor_report=1
+# Publish fine timing measurement (FTM) responder functionality
+# This parameter only controls publishing via Extended Capabilities element.
+# Actual functionality is managed outside hostapd.
+#ftm_responder=0
+
+# Publish fine timing measurement (FTM) initiator functionality
+# This parameter only controls publishing via Extended Capabilities element.
+# Actual functionality is managed outside hostapd.
+#ftm_initiator=0
+
##### TESTING OPTIONS #########################################################
#
# The options in this section are only available when the build configuration