Set default scan IEs to the driver (QCA vendor extension)

[mech_eap.git] / src / drivers / driver_nl80211.c

diff --git a/src/drivers/driver_nl80211.c b/src/drivers/driver_nl80211.c
index be32c5d..7743bd5 100644 (file)
--- a/src/drivers/driver_nl80211.c
+++ b/src/drivers/driver_nl80211.c
@@ -3706,7 +3706,7 @@ static int wpa_driver_nl80211_set_ap(void *priv,
                                           "nl80211: Frequency set succeeded for ht2040 coex");
                                bss->bandwidth = params->freq->bandwidth;
                        }
-               } else if (!beacon_set) {
+               } else if (!beacon_set && params->freq) {
                        /*
                         * cfg80211 updates the driver on frequence change in AP
                         * mode only at the point when beaconing is started, so
@@ -9469,6 +9469,7 @@ const struct wpa_driver_ops wpa_driver_nl80211_ops = {
        .set_prob_oper_freq = nl80211_set_prob_oper_freq,
        .p2p_lo_start = nl80211_p2p_lo_start,
        .p2p_lo_stop = nl80211_p2p_lo_stop,
+       .set_default_scan_ies = nl80211_set_default_scan_ies,
 #endif /* CONFIG_DRIVER_NL80211_QCA */
        .configure_data_frame_filters = nl80211_configure_data_frame_filters,
        .get_ext_capab = nl80211_get_ext_capab,