*
* scan_ssid can be used to scan for APs using hidden SSIDs.
* Note: Many drivers do not support this. ap_mode=2 can be used with
- * such drivers to use hidden SSIDs.
+ * such drivers to use hidden SSIDs. Note2: Most nl80211-based drivers
+ * do support scan_ssid=1 and that should be used with them instead of
+ * ap_scan=2.
*/
int scan_ssid;
} mode;
/**
+ * pbss - Whether to use PBSS. Relevant to DMG networks only.
+ * 0 = do not use PBSS
+ * 1 = use PBSS
+ * 2 = don't care (not allowed in AP mode)
+ * Used together with mode configuration. When mode is AP, it
+ * means to start a PCP instead of a regular AP. When mode is INFRA it
+ * means connect to a PCP instead of AP. In this mode you can also
+ * specify 2 (don't care) meaning connect to either AP or PCP.
+ * P2P_GO and P2P_GROUP_FORMATION modes must use PBSS in DMG network.
+ */
+ int pbss;
+
+ /**
* disabled - Whether this network is currently disabled
*
* 0 = this network can be used (default).
*/
int fixed_freq;
+#ifdef CONFIG_ACS
+ /**
+ * ACS - Automatic Channel Selection for AP mode
+ *
+ * If present, it will be handled together with frequency.
+ * frequency will be used to determine hardware mode only, when it is
+ * used for both hardware mode and channel when used alone. This will
+ * force the channel to be set to 0, thus enabling ACS.
+ */
+ int acs;
+#endif /* CONFIG_ACS */
+
/**
* mesh_basic_rates - BSS Basic rate set for mesh network
*
int vht;
+ u8 max_oper_chwidth;
+
+ unsigned int vht_center_freq2;
+
/**
* wpa_ptk_rekey - Maximum lifetime for PTK in seconds
*
* this MBSS will trigger a peering attempt.
*/
int no_auto_peer;
+
+ /**
+ * wps_disabled - WPS disabled in AP mode
+ *
+ * 0 = WPS enabled and configured (default)
+ * 1 = WPS disabled
+ */
+ int wps_disabled;
};
#endif /* CONFIG_SSID_H */