mesh: Mark wpa_state COMPLETED when mesh join has been performed

In mesh interface, the wpa_supplicant state was either
DISCONNECT/SCANNING in non-secured connection or AUTHENTICATING in
secured connection. The latter prevented the scan. Update the
wpa_supplicant state in mesh to be COMPLETED upon initialization. This
is similar to the P2P GO case.

Signed-off-by: Maital Hahn <maitalm@ti.com>

diff --git a/wpa_supplicant/mesh.c b/wpa_supplicant/mesh.c
index bf9beb2..dd534d4 100644 (file)
--- a/wpa_supplicant/mesh.c
+++ b/wpa_supplicant/mesh.c
@@ -445,6 +445,9 @@ int wpa_supplicant_join_mesh(struct wpa_supplicant *wpa_s,
        /* hostapd sets the interface down until we associate */
        wpa_drv_set_operstate(wpa_s, 1);
 
+       if (!ret)
+               wpa_supplicant_set_state(wpa_s, WPA_COMPLETED);
+
 out:
        return ret;
 }

diff --git a/wpa_supplicant/mesh_rsn.c b/wpa_supplicant/mesh_rsn.c
index c5f5d69..2eec227 100644 (file)
--- a/wpa_supplicant/mesh_rsn.c
+++ b/wpa_supplicant/mesh_rsn.c
@@ -363,7 +363,6 @@ int mesh_rsn_auth_sae_sta(struct wpa_supplicant *wpa_s,
                "AUTH: started authentication with SAE peer: " MACSTR,
                MAC2STR(sta->addr));
 
-       wpa_supplicant_set_state(wpa_s, WPA_AUTHENTICATING);
        ret = auth_sae_init_committed(hapd, sta);
        if (ret)
                return ret;