1 This is radsecproxy 1.4.2 from November 23 2010.
3 radsecproxy is a generic RADIUS proxy that supports both UDP and TLS
4 (RadSec) RADIUS transports. There is also experimental support for
7 It should build on most Linux and BSD platforms by simply typing
8 "./configure && make". It is possible to specify which RADIUS
9 transport the build should support. Without any special options to
10 configure, all transports supported by the system will be enabled.
11 See the output from "configure --help" for how to change this.
14 - Older BSD's (like NetBSD 4.x) need newer OpenSSL in order to support
15 DTLS. Workaround: ./configure --disable-dtls.
16 - FreeBSD 6.x needs newer OpenSSL to build at all.
18 To use radsecproxy you need to create a config file which normally is
19 called "/etc/radsecproxy.conf". You can also specify the location
20 with the "-c" command line option (see below). For further
21 instructions, please see the enclosed example file and the
23 http://software.uninett.no/radsecproxy/?page=documentation
25 There are five options that may be specified on the command line:
26 "-c configfile" to specify a non-default config file path.
27 "-d loglevel" to set a loglevel of 1, 2, 3, 4 and 5 where 5 is the
29 "-f" to run the proxy in the foreground with logging to stderr.
30 Without "-f" the default is to detach as a daemon and log to
32 "-v" just prints version information and exits.
33 "-p" (pretend) makes the proxy go through the configuration files as
34 normal, but stops before creating any sockets or doing any
35 serious work. This is useful for validating config files.