Set the station to authorized on assoc event for open authentication

This was done in handle_assoc_cb() in ieee802_11.c for drivers that use
hostapd SME/MLME. However, drivers that include SME/MLME implementation
do not use that function and the STA flag needs to be set when
processing the association notification. This is needed to get the STA
entry into showing the proper authorized state and to get the
AP-STA-CONNECTED/DISCONNECTED events on the control interface.

Signed-off-by: Jouni Malinen <jouni@qca.qualcomm.com>

diff --git a/src/ap/hostapd.c b/src/ap/hostapd.c
index 6ba6f98..e7ff04a 100644 (file)
--- a/src/ap/hostapd.c
+++ b/src/ap/hostapd.c
@@ -2027,6 +2027,7 @@ void hostapd_new_assoc_sta(struct hostapd_data *hapd, struct sta_info *sta,
         * IEEE 802.1X/WPA code will start accounting after the station has
         * been authorized. */
        if (!hapd->conf->ieee802_1x && !hapd->conf->wpa) {
+               ap_sta_set_authorized(hapd, sta, 1);
                os_get_reltime(&sta->connected_time);
                accounting_sta_start(hapd, sta);
        }