QCA vendor command to configure GPIO pins

This commit introduces a new vendor sub command
QCA_NL80211_VENDOR_SUBCMD_GPIO_CONFIG_COMMAND and associated
attributes to configure GPIO pins.

Signed-off-by: Jouni Malinen <jouni@qca.qualcomm.com>

diff --git a/src/common/qca-vendor.h b/src/common/qca-vendor.h
index 36450e9..740ee8c 100644 (file)
--- a/src/common/qca-vendor.h
+++ b/src/common/qca-vendor.h
@@ -115,6 +115,9 @@ enum qca_radiotap_vendor_ids {
  *     indicated through an event using the same sub command through
  *     @QCA_WLAN_VENDOR_ATTR_SAP_CONDITIONAL_CHAN_SWITCH_STATUS. Attributes are
  *     listed in qca_wlan_vendor_attr_sap_conditional_chan_switch.
+ *
+ * @QCA_NL80211_VENDOR_SUBCMD_GPIO_CONFIG_COMMAND: Set GPIO pins. This uses the
+ *     attributes defined in enum qca_wlan_gpio_attr.
  */
 enum qca_nl80211_vendor_subcmds {
        QCA_NL80211_VENDOR_SUBCMD_UNSPEC = 0,
@@ -200,6 +203,7 @@ enum qca_nl80211_vendor_subcmds {
        QCA_NL80211_VENDOR_SUBCMD_P2P_LISTEN_OFFLOAD_START = 122,
        QCA_NL80211_VENDOR_SUBCMD_P2P_LISTEN_OFFLOAD_STOP = 123,
        QCA_NL80211_VENDOR_SUBCMD_SAP_CONDITIONAL_CHAN_SWITCH = 124,
+       QCA_NL80211_VENDOR_SUBCMD_GPIO_CONFIG_COMMAND = 125,
 };
 
 
@@ -736,4 +740,26 @@ enum qca_wlan_vendor_attr_sap_conditional_chan_switch {
        QCA_WLAN_VENDOR_ATTR_SAP_CONDITIONAL_CHAN_SWITCH_AFTER_LAST - 1,
 };
 
+/**
+ * enum qca_wlan_gpio_attr - Parameters for GPIO configuration
+ */
+enum qca_wlan_gpio_attr {
+       QCA_WLAN_VENDOR_ATTR_GPIO_PARAM_INVALID = 0,
+       /* Unsigned 32-bit attribute for GPIO command */
+       QCA_WLAN_VENDOR_ATTR_GPIO_PARAM_COMMAND,
+       /* Unsigned 32-bit attribute for GPIO PIN number to configure */
+       QCA_WLAN_VENDOR_ATTR_GPIO_PARAM_PINNUM,
+       /* Unsigned 32-bit attribute for GPIO value to configure */
+       QCA_WLAN_VENDOR_ATTR_GPIO_PARAM_VALUE,
+       /* Unsigned 32-bit attribute for GPIO pull type */
+       QCA_WLAN_VENDOR_ATTR_GPIO_PARAM_PULL_TYPE,
+       /* Unsigned 32-bit attribute for GPIO interrupt mode */
+       QCA_WLAN_VENDOR_ATTR_GPIO_PARAM_INTR_MODE,
+
+       /* keep last */
+       QCA_WLAN_VENDOR_ATTR_GPIO_PARAM_LAST,
+       QCA_WLAN_VENDOR_ATTR_GPIO_PARAM_MAX =
+       QCA_WLAN_VENDOR_ATTR_GPIO_PARAM_LAST - 1
+};
+
 #endif /* QCA_VENDOR_H */