Define QCA vendor config attribute to set default scan IEs to the driver

Signed-off-by: Jouni Malinen <jouni@qca.qualcomm.com>

diff --git a/src/common/qca-vendor.h b/src/common/qca-vendor.h
index 912d1e1..798edc1 100644 (file)
--- a/src/common/qca-vendor.h
+++ b/src/common/qca-vendor.h
@@ -668,6 +668,17 @@ enum qca_wlan_vendor_attr_config {
         * packet count. The peer is disconnected once this threshold is
         * reached. */
        QCA_WLAN_VENDOR_ATTR_CONFIG_TX_FAIL_COUNT,
+       /* Attribute used to set scan default IEs to the driver.
+        *
+        * These IEs can be used by scan operations that will be initiated by
+        * the driver/firmware.
+        *
+        * For further scan requests coming to the driver, these IEs should be
+        * merged with the IEs received along with scan request coming to the
+        * driver. If a particular IE is present in the scan default IEs but not
+        * present in the scan request, then that IE should be added to the IEs
+        * sent in the Probe Request frames for that scan request. */
+       QCA_WLAN_VENDOR_ATTR_CONFIG_SCAN_DEFAULT_IES,
 
        /* keep last */
        QCA_WLAN_VENDOR_ATTR_CONFIG_AFTER_LAST,