import subprocess
import hostapd
-from utils import HwsimSkip, skip_with_fips
+from utils import HwsimSkip, skip_with_fips, alloc_fail
import hwsim_utils
from tshark import run_tshark
from wlantest import Wlantest
if res1['anqp_nai_realm'] == res2['anqp_nai_realm']:
raise Exception("ANQP results were not unshared")
+def test_ap_anqp_sharing_oom(dev, apdev):
+ """ANQP sharing within ESS and explicit unshare OOM"""
+ check_eap_capa(dev[0], "MSCHAPV2")
+ dev[0].flush_scan_cache()
+
+ bssid = apdev[0]['bssid']
+ params = hs20_ap_params()
+ params['hessid'] = bssid
+ hostapd.add_ap(apdev[0], params)
+
+ bssid2 = apdev[1]['bssid']
+ params = hs20_ap_params()
+ params['hessid'] = bssid
+ params['nai_realm'] = [ "0,example.com,13[5:6],21[2:4][5:7]" ]
+ hostapd.add_ap(apdev[1], params)
+
+ dev[0].hs20_enable()
+ id = dev[0].add_cred_values({ 'realm': "example.com", 'username': "test",
+ 'password': "secret",
+ 'domain': "example.com" })
+ dev[0].scan_for_bss(bssid, freq="2412")
+ dev[0].scan_for_bss(bssid2, freq="2412")
+ interworking_select(dev[0], None, "home", freq="2412")
+ dev[0].dump_monitor()
+
+ with alloc_fail(dev[0], 1, "wpa_bss_anqp_clone"):
+ dev[0].request("ANQP_GET " + bssid + " 263")
+ ev = dev[0].wait_event(["RX-ANQP"], timeout=5)
+ if ev is None:
+ raise Exception("ANQP operation timed out")
+
def test_ap_nai_home_realm_query(dev, apdev):
"""NAI Home Realm Query"""
check_eap_capa(dev[0], "MSCHAPV2")
with alloc_fail_dbus(dev[0], 1, "=wpas_dbus_getter_bss_rates", "Get"):
bss_obj.Get(WPAS_DBUS_BSS, "Rates",
dbus_interface=dbus.PROPERTIES_IFACE)
+ with alloc_fail(dev[0], 1,
+ "wpa_bss_get_bit_rates;wpas_dbus_getter_bss_rates"):
+ try:
+ bss_obj.Get(WPAS_DBUS_BSS, "Rates",
+ dbus_interface=dbus.PROPERTIES_IFACE)
+ except dbus.exceptions.DBusException, e:
+ pass
id = dev[0].add_network()
dev[0].set_network(id, "disabled", "0")
import hostapd
from wpasupplicant import WpaSupplicant
from tshark import run_tshark
-from utils import alloc_fail, skip_with_fips
+from utils import alloc_fail, wait_fail_trigger, skip_with_fips
from hwsim import HWSimRadio
def hs20_ap_params():
dev[0].scan_for_bss(bssid, freq="2412", force_scan=True)
+ with alloc_fail(dev[0], 1, "wpa_bss_anqp_alloc"):
+ if "OK" not in dev[0].request("ANQP_GET " + bssid + " 258"):
+ raise Exception("ANQP_GET command failed")
+ ev = dev[0].wait_event(["ANQP-QUERY-DONE"], timeout=5)
+ if ev is None:
+ raise Exception("ANQP query did not complete")
+
with alloc_fail(dev[0], 1, "gas_build_req"):
if "FAIL" not in dev[0].request("ANQP_GET " + bssid + " 258"):
raise Exception("Unexpected ANQP_GET command success (OOM)")
wpas.request("SET preassoc_mac_addr 0")
wpas.dump_monitor()
+ hapd = hostapd.add_ap(apdev[0], { "ssid": "open" })
+ with alloc_fail(dev[0], 1, "wpa_bss_add"):
+ dev[0].scan_for_bss(apdev[0]['bssid'], freq="2412")
+
def test_scan_freq_list(dev, apdev):
"""Scan with SET freq_list and scan_cur_freq"""
try:
dev[0].request("SET scan_cur_freq 0")
dev[0].request("REMOVE_NETWORK all")
dev[0].wait_disconnected()
+
+def test_scan_bss_limit(dev, apdev):
+ """Scan and wpa_supplicant BSS entry limit"""
+ try:
+ _test_scan_bss_limit(dev, apdev)
+ finally:
+ dev[0].request("SET bss_max_count 200")
+ pass
+
+def _test_scan_bss_limit(dev, apdev):
+ # Trigger 'Increasing the MAX BSS count to 2 because all BSSes are in use.
+ # We should normally not get here!' message by limiting the maximum BSS
+ # count to one so that the second AP would not fit in the BSS list and the
+ # first AP cannot be removed from the list since it is still in use.
+ dev[0].request("SET bss_max_count 1")
+ hapd = hostapd.add_ap(apdev[0], { "ssid": "test-scan" })
+ dev[0].connect("test-scan", key_mgmt="NONE", scan_freq="2412")
+ hapd2 = hostapd.add_ap(apdev[1], { "ssid": "test-scan-2",
+ "channel": "6" })
+ dev[0].scan_for_bss(apdev[1]['bssid'], freq=2437, force_scan=True)